PK_ERROR_code_t  PK_CURVE_make_wire_body
(
--- received arguments ---
PK_CURVE_t       curve,     --- curve
PK_INTERVAL_t    range,     --- extent of curve

--- returned arguments ---
PK_BODY_t *const body       --- wire body returned
)


This function creates a wire body from a curve.

NOTE: This function is obsolete and has been superseded by
PK_CURVE_make_wire_body_2.


Specific Errors:
    PK_ERROR_invalid_geometry       geometry fails to pass checks
    PK_ERROR_bad_shared_dep         dependent of entity would be illegally
                                    shared
    PK_ERROR_non_manifold           resulting body would be non-manifold
    PK_ERROR_bad_parameter          parametric limit not valid on curve
    PK_ERROR_cant_extract_geom      failed to extract geometry


The part of the curve required must be defined by the parametric interval
range.  The wire may be closed. If the wire body crosses the seam of a closed
curve, then the parameterisation of the curve must be periodic.

If the curve is an orphan, then it will be used as the geometry of the
body, otherwise a copy of it will be used as the geometry of the body.