GMOperatorsInterfaces Global Function CATCGMCreateTopSplitShellWithKeepRemove

Constructs an operator that splits a CATShell domain by a CATShell or a CATWire domain.
The body to split and the cutting body must only contain one shell domain and one (shell or wire) domain respectively.
Orientation: The orientation of the resulting body is the orientation of the body to cut.
Journal:

• The faces that are kept and not cut are written as CATCGMJournal::Keep
• The faces that are cut are written as CATCGMJournal::Subdivision
• The new edges are written as CATCGMJournal::Creation
• The faces that are neither cut, nor kept, are written as CATCGMJournal::Deletion

Parameters:

iFactory

A pointer to the factory of the resulting body.

iData

A pointer to the topological data.

iBodyToCut

A pointer to the body to cut. It must only contain one shell domain.

iCuttingBody

A pointer to the cutting body. It must only contain one (wire or shell) domain

iExtrapolMode

The extrapolation mode when the cutting body does not cut right along the body to cut, or vice versa in case of a trim operation:

• NO_EXTRAPOLATION: No extrapolation is performed. The operator cannot find a solution if the cutting body does not cut right along the body to cut.
• TANGENT_DIRECTION: If the cutting body does not cut right along the body to cut, the extrapolation is made tangentially to the scar at the last computed point.

iTol

Defines the tolerance of the geometrically coincident elements to be taken into acccount by this operator during the LayDown process.

Returns:

[out, IUnknown#Release] The pointer to the created operator. To be released with the Release method afer use.

Copyright © 1999-2015, Dassault Systèmes. All rights reserved.