GMOperatorsInterfaces CATICGMWireExtrapolationOp

Usage: you must use this class as is. You should never derive it.

public class CATICGMWireExtrapolationOp

Class defining the extrapolation operator on a wire body.
To use it:

• Create it with the CATCGMCreateWireExtrapolationOp global function.
• Tune it with appropriate options, using the SetXxx methods.
• Run it
• Get the resulting GetResult method. If you do not want to keep these resulting body, use the method to remove them from the geometric factory, after the operator deletion.
• Release the operator with the Release method after use.

  ---

  Constructor and Destructor Index

  
  

  o CATICGMWireExtrapolationOp()

  Constructor

  Method Index

  
  

  o GetFreezeMode()

  Returns the mode in which the resulting body is created.

  o GetResult()

  Returns a pointer to the resulting CATBody of this operator.

  o Run()

  Runs this operator.

  o SetExtrapolation(CATVertex*,double)

  Set extrapolation length for specified vertex.

  o SetFreezeMode(CATBodyFreezeMode)

  Defines the state of the resulting body.

  Constructor and Destructor

  
  
  o CATICGMWireExtrapolationOp

  public CATICGMWireExtrapolationOp(

  )

  Constructor

  Methods

  
  
  o GetFreezeMode

  public virtual GetFreezeMode(

  )

  Returns the mode in which the resulting body is created.

  Returns:

  The smart mode.

  o GetResult

  public virtual GetResult(

  )

  Returns a pointer to the resulting CATBody of this operator.
  Must be called after the Run method.

  o Run

  public virtual Run(

  )

  Runs this operator.

  o SetExtrapolation

  public virtual SetExtrapolation(		iVertex,
  		iLength)

  Set extrapolation length for specified vertex.

  Parameters:

  iVertex

  The vertex to be extrapolated.

  iLength

  The extrapolation length.

  o SetFreezeMode

  public virtual SetFreezeMode(

  iOnOrOff)

  Defines the state of the resulting body.

  Parameters:

  iOnOrOff

  The state of the resulting body.

  ---

  This object is included in the file: CATICGMWireExtrapolationOp.h
  If needed, your Imakefile.mk should include the module: CATGMOperatorsInterfaces

  ---

  Copyright © 1999-2015, Dassault Systèmes. All rights reserved.